Nissan Rogue Door Sensor Problem: Common Causes Along with Solutions

The Nissan Rogue is a popular SUV known for its affordable pricing and comfortable ride. 

However, some model years of the Rogue have reported issues with the door sensors that malfunctions. 

This article will provide an overview of the common problems with Rogue door sensors and some troubleshooting tips.

Common Door Sensor Problems

Faulty door latch/ajar sensor

• One of the most common issues with Nissan Rogue door sensors is a faulty latch or an ajar sensor. 

• This sensor detects when a door is not fully latched or closed properly. 

• When it malfunctions, it can cause warning lights on the dash, dome lights to remain on, and other electrical issues to appear.

Moisture accumulation in wiring

• The wiring for the Nissan Rogue door sensors can accumulate moisture over time, especially if drain holes become clogged. 

• This moisture can lead to corrosion and sensor failure.

Damaged wiring harness

• The wiring harness that connects to the door sensors can become damaged over time from opening and closing doors. 

• This can interrupt the sensor signal and cause issues in the long run.

Troubleshooting Tips

Inspect the Sensor Functionality

• Check whether the dome light comes on when opening each door. 

• The dome light should activate when any door is opened by indicating the sensor is working properly.

• Have a deep look for warning lights on the instrument panel that is related to door sensors while opening and closing doors one at a time. 

• This includes the airbag warning lights as well.

• Test the power door locks and power windows at each door. 

• If they are inoperative, it might indicate an issue with the door sensors and wiring. 

.Check for Moisture Accumulation

• Examine the access holes along the bottom edges of the doors where water drains out. 

• Clear out mud, dirt, leaves or other debris with a small tool.

• Peel back the floor carpets and insulation in the interior to check for wetness. 

• This is because any water intrusion can lead to sensor or wiring corrosion over time.

• Use a hair dryer to thoroughly dry out any identified moisture on wiring harnesses before reassembling the trim panels.

Test the Sensor’s Electrical Connections

• Use a digital multimeter or a dedicated automotive circuit tester to check for the wiring harness continuity between the door sensors and the vehicle computer.

• Check the connectors at the sensors and at the computer for loose wires, damaged pins, or corrosion that interrupts the signals.

• Ground wires may also become damaged from moisture. Therefore, check the ground points with a multimeter for conductivity as well.

Reset the Door Sensor Systems

• Most Rogues have an option to reset or recalibrate the door sensors through an instrument panel menu option. This reestablishes the baseline readings.

• Some years requires disconnecting the battery cables for 30 minutes to do a hard reset of all sensors. Refer to the factory service manual for procedures.

Replace the Damaged Sensors

• Rogue door sensors are integrated into the latch assembly that are mounted inside the doors. The entire latch must be replaced if non-repairable.

• Use some dealer scanner tools to see if the replacement resolves any error codes that are related to the door circuit faults before any reassembling.

• Install an updated sensor design if moisture corrosion was evident. Remember that newer versions have improved sealing and harness routing.

Frequently Asked Questions About Nissan Rogue Door Sensor Problem

Q: Can bad door sensors prevent my Rogue from starting?

A: It is possible for certain faults with door latches or sensors to trigger an immobilizer system fault that prevents the vehicle from starting properly. 

Q: How much does it cost to replace the Nissan Rogue door sensors?

A: On average, replacing a single faulty door latch/sensor assembly can cost $125-$350 for parts and labor. The cost can vary change due to few factors, such as the shop, vehicle year, and the parts availability.